TE-PM ECU

This controller model is the base for a whole family of gas controllers such as TE-PS and TE-SL. This distributed gas injection controller, like no other device from TEGAS engineering, included the most advanced gas injection control algorithms.

Works with LPG and CNG
Works with 3-4 cyl. Engines
Simple and fast installation
Compact body
Innovative auto-calibration that does not require the collection of map points at power
Work with all common types of fuel injection
Additional injection of gasoline
Gas leak control
Software tank gas level sensor
Virtual revolutions
Winter operation of gas nozzles
Preheating of gas injectors
Work with all types of gas level sensors in the cylinder
Correction by OBD (works with TE-Z8 and according to ISO9141 and KWP2000 protocols)
Controllers TE-PM, as well as TE-PS and TE-SL, are equipped with semiconductor emulators of petrol injectors. Electrical resistance - 100 Ohm.

Working with OBD

Initially, the TE-PM controller does not provide the ability to connect to the OBD diagnostic bus. However, thanks to the TE-Z8 device, there is such an opportunity. The TE-Z8 device, via the diagnostic data bus (OBD), requests data on short-term and long-term corrections of the engine fuel mixture. The received data is converted into an analog signal, which is fed to the lambda probe connection wire. Then, using internal algorithms, the controller corrects the gas supply.

TE-Z8 works with the following protocols: ISO-9141, KWP2000 (fast/slow).

This controller model is the base for a whole family of gas controllers such as TE-PS and TE-SL. This distributed gas injection controller, like no other device from TEGAS engineering, included the most advanced gas injection control algorithms.

Works with LPG and CNG
Works with 3-4 cyl. Engines
Simple and fast installation
Compact body
Innovative auto-calibration that does not require the collection of map points at power
Work with all common types of fuel injection
Additional injection of gasoline
Gas leak control
Software tank gas level sensor
Virtual revolutions
Winter operation of gas nozzles
Preheating of gas injectors
Work with all types of gas level sensors in the cylinder
Correction by OBD (works with TE-Z8 and according to ISO9141 and KWP2000 protocols)
Controllers TE-PM, as well as TE-PS and TE-SL, are equipped with semiconductor emulators of petrol injectors. Electrical resistance - 100 Ohm.

Working with OBD

Initially, the TE-PM controller does not provide the ability to connect to the OBD diagnostic bus. However, thanks to the TE-Z8 device, there is such an opportunity. The TE-Z8 device, via the diagnostic data bus (OBD), requests data on short-term and long-term corrections of the engine fuel mixture. The received data is converted into an analog signal, which is fed to the lambda probe connection wire. Then, using internal algorithms, the controller corrects the gas supply.

TE-Z8 works with the following protocols: ISO-9141, KWP2000 (fast/slow).